HONTEC is one of leading High Frequency PCB manufacture, who specializes in high-mix,low volume and quickturn prototype PCB for high-tech industries in 28 countries.
Our High Frequency PCB has passed UL, SGS and ISO9001 certification, we are in application of ISO14001 and TS16949 as well.
Located in Shenzhen of GuangDong, HONTEC partners up with UPS, DHL and world-class forwarders to provide efficient shipping services. Welcome to buy High Frequency PCB from us. Every request from customers is being replied within 24 hours.
With the rapid development of information technology, the trend of high-frequency and high-speed information processing is becoming more and more obvious. The demand for PCBs that can be used at low and high frequencies is increasing. For PCB manufacturers, timely and accurate grasp of market needs and The development trend will make the enterprise invincible. And the finished board has good dimensional stability. The following is about Ro3003 High Frequency PCB related, I hope to help you better understand Ro3003 High Frequency PCB.
High-frequency mixed-press material step board manufacturing technology is a circuit board manufacturing technology that has emerged with the rapid development of the communications and telecommunications industries. It is mainly used to break through the high-speed data and high information content that traditional printed circuit boards cannot reach. The bottleneck of transmission. The following is about AD250 PCB related, I hope to help you better understand AD250 PCB.
For general frequency, use FR-4 sheet, but high-frequency materials should be used in the frequency ratio of 1-5G, such as semi-ceramic materials. ROGERS 4350, 4003, 5880, etc. are commonly used ... If the frequency is higher than 5G, it is best to use PTFE material, which is polytetrafluoroethylene. This material has good high-frequency performance, but there are limitations in the processing arts, such as the surface technology that cannot be hot air leveled. The following is about ISOLA FR408 High Frequency PCB related, I hope to help you better understand ISOLA FR408 High Frequency PCB.
The frequency of vehicle millimeter wave radar is mainly divided into 24GHz frequency band and 77GHz frequency band, of which 77GHz frequency band represents the future trend. The reliability of 77G radar board is very important. It is related to the safety of car driving. Among them, the reliability of electroplating is the most important factor affecting its reliability. The following is about Car Collision Avoidance Radar PCB related, I hope to help you better understand Car Collision Avoidance Radar PCB.
The delay per unit inch on the PCB is 0.167ns. However, if there are more vias, more device pins, and more constraints set on the network cable, the delay will increase. Generally, the signal rise time of high-speed logic devices is about 0.2ns. If there are GaAs chips on the board, the maximum wiring length is 7.62mm. The following is about RO3003 PCB related, I hope to help you better understand RO3003 PCB.
Signal transmission occurs at the moment when the signal state changes, such as rise or fall time. The signal passes a fixed time from the driving end to the receiving end. If the transmission time is less than 1/2 of the rise or fall time, the reflected signal from the receiving end will reach the driving end before the signal changes state. Conversely, the reflected signal will reach the drive end after the signal changes state. If the reflected signal is strong, the superimposed waveform may change the logic state. The following is about 12 Layer Taconic High Frequency Board related, I hope to help you better understand 12-Layer Taconic High Frequency PCB.
